ABB i-bus KNX Product Manual page 107


ABB i-bus KNX
Start-up
No.
32
If a telegram with the value 2 (binary 10) is received at this communication object, then the blind/shutter is raised. Operation
via direct and automatic communication objects is disabled.
If a telegram with the value 3 (binary 11) is received, then the blind/shutter is lowered. Operation via direct and automatic
communication objects is disabled.
Forced operation is rescinded by the values 0 (binary 00) or 1 (binary 01). The blind/shutter then moves to the parameterized
position for the removal of Wind alarm, Block and Forced operation. Operation via the direct and automatic communication
objects is enabled again.
Telegram value:
33
The output sends the current positioned height of the blind/shutter to this communication object. The current position is sent
after completion of a movement.
Telegram value:
34
The output sends the current position of the slat setting to this communication object. The current position is sent after
completion of a movement.
Telegram value:
35
36
The output sends information to this communication object as to whether the blind/shutter is, or is not, in the upper or lower
end limit position.
Telegram value:
The upper/lower status position is sent after the upper/lower end position is reached or exited.
37
The output sends information to this communication object if the output operation is enabled or blocked. Operation is blocked
is either one of the safety functions has been activated, e.g. wind alarm, or if the device is in manual operation.
Example: An LED on the push button can display to the user that the operation of the output is not possible via push buttons
and the automatic control also cannot be activated.
Telegram value:
Function
Forced operation 2 bit
0 (binary 00) = Operation enabled
1 (binary 01) = Operation enabled
2 (binary 10) = OPEN/Operation disabled
3 (binary 11) = CLOSED/Operation disabled
Status Height [0...255]
0 = Top
...
= Intermediate position
255 = Bottom
Status Slat [0...255]
Note
This communication object is only available in the Control with slat adjustment operation mode.
0 = OPEN slats
...
= Intermediate position
255 = CLOSE slats
Status Upper end position
Status Lower end position
0 = Blind/shutter not in upper or lower end position
1 = Blind/shutter in upper or lower end position
Status Operability
0 = Operation enabled
1 = Operation disabled
Object name
Output A
Output A
Output A
Output A
Output A
Data type Flags
2 bit C, R, T, U
DPT 2.002
1-byte C, R, T
DPT 5.001
1-byte C, R, T
DPT 5.001
1 bit C, R, T
DPT 1.008
1 bit C, R, T
DPT 1.002
JRA/S | 2CDC 506 051 D0204 105