Communication Objects General - ABB i-bus KNX Product Manual


ABB i-bus KNX
Start-up
3.3.2

Communication objects General

These communication objects are only available once per device for all operation modes and serve the
interdisciplinary functions.
No.
0
The communication object is enabled if the parameter Send communication object "In operation" in the General parameter
window was selected as Yes.
In order to monitor the operation of the blind/roller shutter actuator at regular intervals, an In operation telegram can be sent
cyclically to the bus.
As long as the communication object is activated, it sends a parameterizable In operation telegram.
1
If a telegram with the value x (x = 0/1/0 or 1) is received at this communication object, all the status objects are sent to the
bus, as long as they were not programmed with the option On change or request.
Option x = 1 produces the following function:
Telegram value:
2
Using this communication object, Manual operation is disabled or enabled.
Using the value 0, the button
Using the value 1, the button
Telegram value:
3
This communication object indicates whether manual operation is activated.
Telegram value:
The status of manual operation is sent, depending on parameterization, On change, On request and On change or request.
Function
In operation
Request status values
1 = All status messages, provided they are programmed with the option On change or request,
are sent.
0 = No reaction.
Disable/enable man. operation
is enabled on the device.
is disabled on the device.
0 = Button enabled
1 = Button disabled
Status Man. operation
0 = Manual operation not active
1 = Manual operation active
Object name
General
General
General
General
Data type Flags
1 bit C, R, T
DPT 1.002
1 bit C, W
DPT 1.017
1 bit C, W
DPT 1.003
1-byte C, R, T
DPT 1.011
JRA/S | 2CDC 506 051 D0204 97