ABB i-bus KNX Product Manual page 34


ABB i-bus KNX
Start-up
General parameterization options
Direct functions
UP/DOWN/STOP
Slat adjustment
Position height/slat [0...255]
Preset Move to position/Set position
Limited UP/DOWN
Enable limitation
Trigger travel detection
Trigger reference movement
8-bit scene
Safety functions
Wind alarm
Rain alarm
Frost alarm
Disable
Forced operation
Reaction after bus voltage
failure/recovery, programming
Automatic functions
Activation of autom. control
Change height/slat position if sunny
Presence
Heating/cooling
Overheat control
Enable/disable automatic control
Enable/disable direct operation
Status messages
Status Height/slat [0...255]
Status Upper/Lower end position
Status Operability
Status Automatic
Status information (2-byte)
 = Characteristic applies
32 2CDC 506 051 D0204 | JRA/S
X.230.5.1 4.24.5.1
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
X.230.2.1 X.230.1.1
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
- -
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■
■ ■