Parameter Window A: Positions/Presets - ABB i-bus KNX Product Manual


ABB i-bus KNX
Start-up
3.2.5.4.1

Parameter window A: Positions/Presets

The preset positions are set in this parameter window. In addition, the way in which the positions are to be
moved to are also set here.
Enable communication objects
"Move to pos. height/Move slat [0...255]"
Options:
The blind/shutter can be moved in a targeted manner to any desired position and the slats positioned in
any slat position via two separate communication objects. Both communication objects are 1-byte
communication objects [0...255].
The following applies to the position of the blind/shutter: The value 0 corresponds to the top position (0 %).
The value 255 corresponds to the bottom position (100 %).
The following applies to the slat position: The value 0 corresponds to the open slat position (0 %). The
value 255 corresponds to the slat position closed (100 %).
Some of these positions are dependent on the appropriate setting of the drive.
The calculation of the slat position is based on the duration and number of steps.
The calculation of the height is based on the total travel time (via manual measurement and input or via
automatic travel detection) of the blind/shutter.

Yes: The communication objects Move to pos. height [0...255] and Move slats [0...255] are enabled.
72 2CDC 506 051 D0204 | JRA/S
Yes
No