ABB i-bus KNX Product Manual page 53


ABB i-bus KNX
Start-up
Reaction after bus voltage recovery
Reaction after programming
or after ETS reset
Options:
This parameter determines the response of the output on bus voltage recovery or after a download and
ETS reset.

No reaction: The output contacts remain in their current position.

Up/Down: The blind/shutter moves up or down.

Stop: If the blind/shutter is performing a movement, this movement stops immediately. If the
blind/shutter is at rest, it will remain unchanged in its position.

Position 1...4: If one of these positions are selected, the blind/shutter moves to a preset position. The
blind/shutter height and slat setting of the corresponding position can be set in parameter window A:
Positions/Presets, p. 72).

Individual position: A freely-definable position is moved to. The following parameters appear.

Enable automatic sun protection: Automatic sun protection is switched on after a bus voltage recovery
or after a download and ETS reset.
No reaction
Up
Down
Stop
Position 1...4
Individual position
Enable automatic sun protection
Position height in % [0...100]
(0% = top; 100% = bottom)
Position Slat in % [0...100]
(0% = open; 100% = closed)
Note
The parameters for slat adjustment are available exclusively in the operation mode Control with
slat adjustment.
Options: 0...100
These parameters specify the height or the slat position of the blind/shutter.
JRA/S | 2CDC 506 051 D0204 51