Parameter Operation Mode: Ventilation Flaps, Switch Mode - ABB i-bus KNX Product Manual


ABB i-bus KNX
Start-up
3.2.6

Parameter Operation mode: Ventilation flaps, switch mode

Operation mode
Options:
This parameter defines the operating mode of the output. The communication objects and the parameters
for the respective outputs differ slightly depending on the operation mode. You can find the description of
the operation modes Control with slat adjustment and Control without slat adjustment from p. 50 onwards.
Note
In the operation mode Ventilation flaps, switch mode, there is a fixed pause on changing direction of
100 ms on each output for switch operations.
Observe the technical data of the drive manufacturer!

Ventilation flaps, switch mode: The following parameters appear:
Reaction on bus voltage failure
Reaction after bus voltage recovery
Reaction after programming
or after ETS reset
Options:
Control with slat adjustment
Control without slat adjustment
Ventilation flaps, switch mode
No reaction
Open/on
Close/off
JRA/S | 2CDC 506 051 D0204 87