ABB i-bus KNX Product Manual page 75


ABB i-bus KNX
Start-up
Enable communication objects
"Move to/set position 1-4" 1 bit
Options:
Up to 4 preset positions can be set for each output. 2 preset positions (1, 2 or 3, 4) are each moved to
using a group address with the values 0 or 1.
This function is particularly suitable for repeated movements to preferred blind/shutter positions, in
conjunction with 1 bit telegrams.
The saved preset positions can be very easily changed without programming the device via the KNX. The
blinds/shutters must be brought to the new required target position. This new position is applies to the
device memory via the communication objects Set position 1, 2 and 3, 4 with the values 0 and 1.
Recall and saving of a preset position can be executed with a single push button. For example, a position
is recalled with a short button push and the current position is saved as the new preset position with a long
button push.

Yes: The communication objects Move to position 1, 2, Move to position 3, 4, Set position 1, 2 and Set
position 3, 4 are enabled. The following parameters also appear:
Yes
No
Overwrite position values (presets)
during download
Options: Yes
No

Yes: The preset positions are overwritten on downloading with the settings in the application.

No: The preset positions previously saved (see above) remain intact on redownloading the
application and are not overwritten with the preset values.
Note
If individual preset values have been set during current operation by a user, the parameter
should then be set to No to ensure that the individual positions are retained!
JRA/S | 2CDC 506 051 D0204 73