ABB i-bus KNX Product Manual page 76


ABB i-bus KNX
Start-up
Move to position
Options:

Directly: The blind/shutter moves from the current position directly to the new target position.

Indirectly via upper or lower end position: The blind/shutter firstly moves to the very top or the very
bottom and only then to the target position.

Indirectly via shortest path: The blind/shutter firstly moves to the very top or very bottom, depending
on which of the two paths is the shorter between the current position and the target position, and then
moves to the target position.
74 2CDC 506 051 D0204 | JRA/S
Position 1: Height in % [0...100]
(0% = top; 100% = bottom)
Position 2: Height in % [0...100]
(0% = top; 100% = bottom)
Position 3: Height in % [0...100]
(0% = top; 100% = bottom)
Position 4: Height in % [0...100]
(0% = top; 100% = bottom)
Options: 0..20..40..60..80..100
These parameters specify the blind/shutter heights for traveling to a preset position.
Position 1: Slat in % [0...100]
(0% = open; 100% = closed)
Position 2: Slat in % [0...100]
(0% = open; 100% = closed)
Position 3: Slat in % [0...100]
(0% = open; 100% = closed)
Position 4: Slat in % [0...100]
(0% = open; 100% = closed)
Note
The parameters for slat adjustment are available exclusively in the operation mode Control with
slat adjustment.
0...20...40...60...80...100
Options:
These parameters specify the slat settings for traveling to a preset position.
Directly
Indirectly via upper end position
Indirectly via lower end position
Indirectly via shortest way