ABB i-bus KNX Product Manual page 16


ABB i-bus KNX
Device technology
Device type
JRA/S 4.24.5.1
* ... = Current version number of the application. Please refer the software information on our homepage for this purpose.
Note
ETS and the current version of the device application program are required for programming.
The current application program is available for download at www.abb.com/knx. After import in the ETS,
it is available in the ETS under ABB/Blind/Switch.
The device does not support the locking function of a KNX device in ETS. If you disable access to all of
the project devices by using a BCU code, it has no effect on this device. Data can still be read and
programmed.
Important
When electronic drives are used, the closed current may not exceed 150 mA, as the automatic travel
detection function is otherwise guaranteed. In this case, the travel times must be detected manually for
the drives and entered in the ETS parameters.
Electronic drives with soft start or soft stop are not suitable for control via JRA/S.
14 2CDC 506 051 D0204 | JRA/S
Application program Maximum number of
communication objects
Blind / roller shutter 4f 24 V
129
travel det. M/...*
Maximum number of Maximum number of
group addresses associations
255 255