Conversion - ABB i-bus KNX Product Manual
Blind/roller shutter actuators jra/s
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (187 pages) ,
- Product manual (220 pages)
Table of Contents
Advertisement
ABB i-bus
KNX
Start-up
3.1.1
Conversion
For ABB i-bus
earlier versions of the application program from ETS3.
Furthermore, conversion can be used to transfer the existing parameterization of a device to a different
device.
Note
When the term "channels" is used in ETS, it means inputs and/or outputs. To make the language of
ETS generally valid for as many ABB i-bus
document.
Note
If the number of channels of the target device is larger than the number of inputs/outputs of the source
device, only the first inputs/outputs of the target device are written with the converted data of the source
device. The remaining inputs/outputs retain or are reset to the default values.
Default values for newly added parameters are set after conversion.
®
KNX devices, it is possible to adopt the parameter settings and group addresses from
®
devices as possible, the word channels is used in this
JRA/S | 2CDC 506 051 D0204 33
Advertisement
Table of Contents
