ABB i-bus KNX Product Manual page 88


ABB i-bus KNX
Start-up
Enable communication object
"Status information" 16 bit
Options:
This parameter enables a 16-bit communication object, which can be used to read out, send or poll
additional status information.

Yes: The communication object Status information is enabled. The following parameter appears:
86 2CDC 506 051 D0204 | JRA/S
Yes
No
Send object value
Options: No, update only
On change
On request
On change or on request

No, only update: The status is updated but not sent (the status can be read via the
communication object).

On change: The status is sent when a change occurs.

On request: The status is sent when a request occurs.

On change or on request: The status is sent on a change or a request.