ABB i-bus KNX Product Manual page 58


ABB i-bus KNX
Start-up

Position 1...4: If one of these positions are selected, the blind/shutter moves to a preset position. The
blind/shutter height and slat setting of the corresponding position can be set in parameter window A:
Positions/Presets, p. 72).

Individual position: A freely-definable position is moved to. The following parameters appear:
According to object value: During a safety alarm, incoming KNX telegrams are saved to the following
communication objects.
Move to height position [0...255]
Move slats [0...255]
Move to position 1, 2
Move to position 3, 4
Scenes
The status of the output is updated to correspond to the current values of the communication objects,
e.g. automatic control is activated after the lifting of a safety alarm. If no new telegrams have been
received in the meantime, then the blind/shutter is moved to the position in which it was when the
safety alarm occurred.
Note
The set position for reset is only moved to when automatic sun protection is deactivated.
Disable automatic sun protection
on reset of safety function
Options:

No: After rescinding of a safety function (e.g. wind alarm), automatic sun protection is reactivated.

Yes: After rescinding of a safety function (e.g. wind alarm), automatic sun protection is deactivated.
56 2CDC 506 051 D0204 | JRA/S
Position Height in % [0...100]
(0% = top; 100% = bottom)
Position Slat in % [0...100]
(0% = open; 100% = closed)
Note
The parameters for slat adjustment are available exclusively in the operation mode Control with
slat adjustment.
These two parameters specify the height or the slat position of the blind/shutter.
Options: 0...100
Yes
No