Siemens SINUMERIK 840DE sl Commissioning Manual page 564

Technologies and cycles
21.5 Turning
MD24910 $MC_TRANSMIT_ROT_SIGN_IS_PLUS_1
= 0
MD24911 $MC_TRANSMIT_POLE_SIDE_FIX_1
= 1
MD24920 $MC_TRANSMIT_BASE_TOOL_1[ ]
[0] = 0
[1] = 0
[2] = 0
Additional settings for rotary axes
If you want to integrate rotary axes, in addition to the following machine data you also require
MD28082 with bit 6, see Chapter "Cylinder surface transformation (TRACYL) (Page 544)".
MD24906 $MC_TRANSMIT_BASE_TOOL_COMP_1
Bit 0
Bit 1
Bit 2
MD24956 $MC_TRANSMIT_BASE_TOOL_COMP_2
Bit 0
Bit 1
Bit 2
For further information, see also Chapter "Clamping a blank (Page 142)".
Face machining under ShopTurn
If you wish to use the face machining function under ShopTurn function, set the following
additional channel-specific configuration machine data:
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 3
Bit 4
550
Sign of the rotary axis for the 1st TRANSMIT transformation.
Limitation of working range in front of/behind the pole, 1st TRANSMIT.
1st geometry axis
2nd geometry axis
3rd geometry axis
1st geometry axis
2nd geometry axis
3rd geometry axis
Enable "internal / rear" machining in ShopTurn screens that define the machining plane
themselves.
If you have implemented the "Clamp/release spindle" function using the machine manufac‐
turer cycle CUST_TECHCYC.SPF, then using this machine data, you can activate the
"Clamp/release spindle" parameter in the drilling and milling screens.
Vector of the base tool for the 1st TRANS‐
MIT transformation.
Compensation of the basic offset in the 1st
transformation frame.
Compensation of the basic offset in the 2nd
transformation frame.
Function screens, ShopTurn.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)