Siemens SINUMERIK 840DE sl Commissioning Manual page 180

Tool management
12.1 Machine data for tool management
12.1.3 Additional settings
Additional settings
You can enable further functions on the user interface via the following machine data / setting
data:
MD52270 $MCS_TM_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
SD54215 $SNS_TM_FUNCTION_MASK_SET
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
166
Creating a tool at the magazine location is not permitted.
Load/unload lock if the machine is not in the reset state.
Load/unload lock for emergency stop.
Loading/unloading or relocating tool in/out of buffer.
Tool loaded directly into spindle.
Using the grinding configuration file.
Relocating a tool in/out of buffer is permitted despite lock (see bit 3).
Tool is created using the number.
Hide tool relocation.
Hide magazine positioning.
Reactivate tool with magazine positioning.
Reactivate tool in all monitoring types.
Hide reactivating tool.
Diameter display for rotating tools.
Cutting edge parameters 6 (tool nose radius) and 15 (wear radius) are not displayed as a
radius value, but as a diameter value for the following tool types: Types 100 to 299, 580,
710, 711, 712, 713, 714 and 725.
Cutting edge parameter 7 (outside radius) is not displayed as a radius value, but as a diam‐
eter value for the following tool types: Types 140 and 714.
M4 is the standard direction of rotation for all turning tools. When creating turning tools, the
direction of rotation is pre-assigned with M4.
A name is not suggested when creating a tool.
Input lock, tool name and tool type for loaded tools. For loaded tools, the tool name and the
tool type can no longer be changed.
Input lock for loaded tools if the channel is not in the reset state.
Tool wear entries are added: Wear data is entered in addition to the already existing wear
value.
Only numerical entries are permitted in the "Tool identifier".
Hide tool monitoring parameters. The tool monitoring parameters are hidden in the user
interface.
Diameter display for face axis - geometry. The geometry value of the transverse axis is
displayed as a diameter value, if a transverse axis is defined in MD20100 $DIAME‐
TER_AX_DEF and SD42940 $TOOL_LENGTH_CONST is set to 18 and SD42950
$TOOL_LENGTH_TYPE is set to 2.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)