Siemens SINUMERIK 840DE sl Commissioning Manual page 523

SD55216 $SCS_FUNCTION_MASK_DRILL_SET
Bit 1
Bit 2
Bit 3
Bit 4
Bit 6
Bit 7
Tapping (CYCLE84 and CYCLE840)
If the technology screens are hidden using the channel-specific configuration machine data
MD52216 $MCS_FUNCTION_MASK_DRILL, then the settings in the following channel-
specific cycle setting data are effective:
SD55481 $SCS_DRILL_TAPPING_SET_GG12[0]
= 0
= 1
= 2
= 3
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Boring CYCLE86: Take into account the rotation of the tool plane when positioning the
spindle
Note:
Spindle direction of rotation M3/ M4 and direction of rotation of the rotary axes must be set
according to DIN. For SPOS=0, the tool cutting edge points in the + direction of the 1st axis
of the plane (for G17, to X+).
= 0 Do not take into account the rotation of the tool plane when positioning the spindle (SPOS).
= 1 Take into account the rotation of the tool plane when positioning the spindle (SPOS).
Boring CYCLE86: When positioning the spindle, take into account swiveled table kinematics
(tool carrier)
= 0 When positioning the spindle, do not take into account the components of the swiveled table
kinematics (swiveling with CYCLE800, tool carrier).
Note:
Only the rotary axis of the machine kinematics that rotates the workpiece is taken into ac‐
count. In the initial state of the kinematics, this rotary axis must be orientated parallel to the
tool axis.
e.g. rotary axis C rotation around Z (for G17) rotary axis vector of the swivel data set V2xyz
= 0 , 0 , -1.
= 1 When positioning the spindle, take into account the components of the swiveled table kine‐
matics (swiveling with CYCLE800, tool carrier).
Tapping CYCLE84: Monitoring of the machine data MD31050 $MA_DRIVE_AX_RATIO_DE‐
NOM and MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
Tapping CYCLE84, set monitoring of the machine data MD31050 $MA_DRIVE_AX_RA‐
TIO_DENOM and MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
= 0 No monitoring
= 1 Monitoring
Boring CYCLE86: Adapt the spindle position to the tool orientation
Tool orientation can be realized using TOOLCARR or TRAORI before the cycle is called.
= 1 Bits 1 and 2 are no longer effective.
Boring CYCLE86: Adapt the direction of retraction travel in the plane to the active mirroring
= 0 Retraction in the plane is realized as programmed.
= 1 When mirroring is active, the direction when retracting in the plane is adapted in the cycle
to the active mirroring.
Exact stop response as before the cycle call (default value).
G601
G602
G603
Technologies and cycles
21.2 Technology cycles for drilling
Drilling function screen form
Setting tapping G group 12:
Block change behavior for exact stop
509