Siemens SINUMERIK 840DE sl Commissioning Manual page 182

Tool management
12.1 Machine data for tool management
Enabling the graphic tool and magazine display function
Make the following settings when the tools and the magazine should be represented
graphically:
MD52271 $MCS_TM_MAG_PLACE_DISTANCE
> 0
= 0
You must make the following settings on the user interface:
1. Press the "Settings" softkey in the "Tool list" window.
The "Settings" window opens.
2. Activate the "Switch on graphical magazine display" checkbox.
This checkbox is offered only when the MD52271 $MCS_TM_MAG_PLACE_DISTANCE
machine data has a value > 0.
Supplementary conditions:
● MD52200 $MCS_TECHNOLOGY = 2 (milling)
● MD52201 $MCS_TECHNOLOGY_EXTENSION = 0
Default settings for unloading/loading and relocating
MD52272 $MCS_TM_TOOL_LOAD_DEFAULT_MAG
= 0
MD52273 $MCS_TM_TOOL_MOVE_DEFAULT_MAG
= 0
MD52274 $MCS_TM_TOOL_LOAD_STATION
= 0
Input limits for wear input
MD51212 $MNS_TM_WRITE_WEAR_ABS_LIMIT
MD51213 $MNS_TM_WRITE_WEAR_DELTA_LIMIT
MD51214 $MNS_TM_WRITE_LIMIT_MASK
168
The tools and magazine locations are displayed graphically.
The tools and magazine locations are not displayed graphically.
No default magazine, default value
No default magazine, default value
All configured stations are considered, default value
Distance between individual magazine lo‐
cations in the unit of measurement of the
basic NC system.
Default magazine for loading tools.
Default magazine for relocating tools.
Number of loading station.
Maximum value of the tool wear.
Maximum differential value of restricted tool
wear input.
Range of validity of the restricted tool wear
input.
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)