Siemens SINUMERIK 840DE sl Commissioning Manual page 197

Identifier
ToolMaxAcc
ToolInMultiTool
ToolInMultiToolPlace
ToolMyMultiTool
ToolMyMultiToolPlace
ToolAlarmIsExtended
ToolAlarmLimit
ToolExtAlarmLimit
ToolUser_1, ... ToolUser_10
ToolAppl_1, ... ToolAppl_10
Parameter corresponds to the system variable or the system variable is the basis for this parameter.
*)
Note
Tool name "ToolIdent"
The maximum length of tool names is 31 ASCII characters.
The number of characters is reduced for Asian characters or Unicode characters.
The following special characters are not permitted: | # "
12.2.2.2 Cutting edge parameter identifiers
For the cutting edge parameters, the following identifiers are used in the configuration file:
Identifier
EdgeNo
EdgeNoIdx
ToolType
CuttEdgePos
GeoLength1
GeoLengthGeoAx1
GeoLengthGeoAx1DiscDiameter
GeoLengthGeoAx1DresserDiameter
GeoLength
GeoLength2
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Parameter or property
Maximum acceleration
Multitool in which the tool is located
Multitool location containing the tool
Owner multitool of the tool
Owner multitool location of the tool
PLC tool status - function "extended alarm" ac‐
tive
PLC tool status - alarm limit reached
PLC tool status - limit "extended alarm" reached -
OEM tool parameters 1 to 10
Siemens application tool parameters 1 to 10
Parameter or property
D number
Cutting edge number
Tool type, cutting edge parameter 1
Cutting edge position, cutting edge param‐
eter 2
Length 1, cutting edge parameter 3
Length of geometry axis 1, cutting edge
parameter 3, e.g. length X
Grinding wheel diameter in geometry axis
1, cutting edge parameter 3
Dressing tool diameter in geometry axis 1,
cutting edge parameter 3
Length, cutting edge parameter 3
Length 2, cutting edge parameter 4
Tool management
12.2 Configuring the user interface
System variable
$TC_TP_MAX_AC
C
$A_TOOLMTN
$A_TOOLMTLN
$A_MYMTN
$A_MYMTLN
-
-
$TC_TPC1, ...
$TC_TPC10
$TC_TPCS1, ...
$TC_TPCS10
System variable
*)
-
-
$TC_DP1
$TC_DP2
$TC_DP3
$TC_DP3
$TC_DP3
$TC_DP3
$TC_DP3
$TC_DP4
*)
183