Siemens SINUMERIK 840DE sl Commissioning Manual page 131

Customizing the "Machine" operating area
Automatic changeover
The circumstances under which an automatic changeover is made into the "Machine" operating
area are set in MD51040 $MNS_SWITCH_TO_MACHINE_MASK.
MD51040 $MNS_SWITCH_TO_MACHINE_MASK
Bit 0 = 1
Bit 1 = 1
Bit 2 = 1
Bit 3 = 1
8.1 Setting the font size of the actual value display
Setting font size
The actual values for the machine coordinate system or workpiece coordinate system can be
displayed in two different font sizes in the "Machine" operating area.
Using a channel machine data item, you can set how many axes should be displayed in a
larger font.
MD52010 $MCS_DISP_NUM_AXIS_BIG_FONT
= 3
8.2 Inserting a user-specific logo
For the traditional SINUMERIK Operate display, the Siemens logo is visible in the "Machine"
operating area in the header.
For the SINUMERIK Operate display of the second generation, the Siemens logo is
permanently displayed in the header.
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
For program selection in the Program Manager, an automatic change is not made into
the Machine operating area.
For program selection in the Program Manager, an automatic change is not made into
the Machine operating area.
When changing over the operating mode via the machine control panel, an automatic
change is not made into the Machine operating area.
For program selection in the Program operating area, an automatic change is not made
into the Machine operating area.
When selecting a program/executing a program in the Program operating area, the block
search is not automatically started.
Number of actual values with a larger font (default setting)
0 (default setting)
Number of actual values with a large
font
8
117