NEC NEAX2400 IMX Features Manual page 104

G-11
Service Conditions (cont'd)
•
Suite Room and Single Room Display
•
Connecting Room Display
When the Console dials a master station, the DSS keys and lamps are used. The status of the connecting room phones appear on the DSS
lamps. Ringing is generated at the connecting room phones when the first DSS key or the START key is pressed. If a subsidiary phone DSS
key is pressed, only the corresponding subsidiary phone will ring. A busy connecting room station will show flashing on the DSS lamp and
an idle connecting room phone will show solid.
If two ordinary rooms are connected, DSS key #1 will display the status of the master room, and DSS key #05 will display the status of the
subsidiary connecting room.
DSS Lamp Status
Lit: Idle
Flashing: Busy
Unlit: No Line
Figure 9 DSS Key/Station Correspondence and Lamp Indications
4. If DSS status display is not set in system data, the guest room rings immediately after being dialed.
5. When the slave room of the SUITE ROOM SERVICE [S-75] is called by the DSS key, TIMING START
[T-21] is not effective.
6. This feature is not available for remote guest stations when Centralized Attendant is used in a CCIS
network.
Page 92
Guest Room Calling – Hotel Attendant
Master Connecting Room
1 2 3 4
Connecting Room
M1 S2 S3 S4
Master Connecting Room
5 6 7 8
M1 S2 S3 S4
NEAX2400 IMX Hotel Features and Specifications
M1 S2
S2 S3
S4
S4
M1
DSS/BLF keys on
Desk Console
NDA-24245, Issue 2