Timing Start - NEC NEAX2400 IMX Features Manual

T-21
T-21
General Description
This feature allows single-digit and multi-digit stations to use the same numbering plan levels by providing a
predetermined time delay between the completion of dialing and the start of ringing. By pressing the # or * key after
dialing the station number, the station user will not have to wait for ring start. By pressing the START key on the
Console, the attendant will not have to wait for ring start.
Operating Procedure
Step
1 Lift handset or press the SPKR key.
2 Dial the desired station.
3 Wait for interdigit timeout or dial # or *.
Service Conditions
1. The Interdigit Timer will be used for TIMING START if a # or * symbol has not been assigned as a
TIMING START character in system data, or if the station user forgets to press the TIMING START
character.
2. Levels can be duplicated for station numbering.
Example: 1st Floor Room No. 11, Station No. 111
11th Floor Room No. 11, Station No. 1111
3. The # or * character cannot be used as the second or third digit of any service feature access code or station
number if it is assigned for TIMING START.
4. The interdigit timer is adjustable through system programming.
5. When TIMING START is used, it is necessary to assign dummy station numbers depending on the number
of digits to be assigned for station numbers.
Example: 4-digit station number = 4xxx
1-digit station number = 4 (TIMING START used)
In the case of data assignment shown in the example above, dummy station numbers of 2 digits=4x and 3
digits=4xx must also be assigned.
4-digit station number = 4xxx
3-digit station number = 4xx
2-digit station number = 4x
1-digit station number = 4
~
Note:
x = 0 9
Page 140

Timing Start

Timing Start
Action
Two stations are to be assigned as dummy stations.
Hear dial tone.
Access to the desired service or station is completed.
NEAX2400 IMX Hotel Features and Specifications
Result
NDA-24245, Issue 2