GE LOGIQ P6 Service Manual page 334

GE H
EALTHCARE
D 5245279, R
IRECTION EVISION
8-4-1 Installing Base Image Software
8.) Press Enter key and then the following screen will be shown. (If you want to abort installation
procedures, press CTRL+C.)
9.) Press A key to install the complete disk.
Select A when installing the new HDD .
NOTICE
Select B when replacing C:\ partition only. It means all customer data are NOT deleted. The Ghost pro-
cedure is performed with data of the drivers D, E, F and Z left."
Select C when replacing C:\ partition and Z:\ partition. It means all customer data are NOT deleted. The
Ghost procedure is performed with data of the drivers D, E and F left. Z:\ partition used for reloading
C:\ partition and Application software will be replaced.
Drive Partition
Table 8-48 Drive Partition
8 - 114
3
Figure 8-169 Base Image Software Installation Menu
(GRUB)
C
D
E
F
Z C:\partition Repository for Reloading Function
Section 8-4 - Software Installation
(cont'd)
Usage
grub data
System Files and Application
User Defined and Preset
Patient Archive data
Swap
LOGIQ™ P6/P6 P S
RO ERVICE
M
ANUAL