GE LOGIQ P6 Service Manual page 353

GE H
EALTHCARE
D 5245279, R
IRECTION EVISION
8-4-4-5 Setting the VCR (if necessary)
1.) Select Utility > System>Peripheral tab
2.) Under Video Settings, PAL or NTSC.
3.) Under VCR, select Composite or S-Video.
4.) Under VCR, select Panasonic LQ-MD800 or Mitsubishi MD3000, as appropriate.
5.) Click on Save.
6.) Shut down the scanner, then restart the scanner.
7.) Verify that the VCR can be properly operated..
Be sure to connect the converter and cablebefore booting up the system. Otherwise the LOGIQ™ P6/
NOTICE
P6 Pro system does not recognize the peripheral devices
8.) Perform the following functional tests. If all are successful, include the debrief script provided below.
Table 8-52
Service Manual
Section 4-3-1
Section 4-3-2
Section 4-5
3
Figure 8-198 Utility > System>Peripheral
Functional Tests
Section Functional Test / Diagnostic Test
Section 8-4 - Software Installation
Power On/Boot Up
Power Off / Shutdown
Peripheral Checks
LOGIQ™ P6/P6 P S
RO ERVICE
Debrief Script
"Service Manual, Direction
5245279, Rev 3+, Section 8-4-4. Equipment
passed all required tests and is ready for use. "
M
ANUAL
8 - 133