IPv4 Filtering Configuration
428
G8264 Command Reference for ENOS 8.4
These commands allow you to define IPv4 matching criteria for an ACL.
Table 200.
IP version 4 Filtering Configuration Options
Command Syntax and Usage
accesscontrol list <1‐256> ipv4 destinationipaddress
<IP address> [<IP mask>]
Defines a destination IP address for the ACL. If defined, traffic with this
destination IP address will match this ACL.
Command mode: Global configuration
no accesscontrol list <1‐256> ipv4 destinationipaddress
Deletes the configured destination IP address for the specified ACL.
Command mode: Global configuration
accesscontrol list <1‐256> ipv4 protocol <0‐255>
Defines an IP protocol for the ACL. If defined, traffic from the specified
protocol matches this filter. Specify the protocol number. Listed below are
some of the well‐known protocols.
Number
Name
1
icmp
2
igmp
6
tcp
17
udp
89
ospf
112
vrrp
Command mode: Global configuration
no accesscontrol list <1‐256> ipv4 protocol
Deletes the configured IP protocol for the specified ACL.
Command mode: Global configuration
accesscontrol list <1‐256> ipv4 sourceipaddress
<IP address> [<IP mask>]
Defines a source IP address for the ACL. If defined, traffic with this source IP
address will match this ACL. Specify an IP address in dotted decimal notation.
Command mode: Global configuration
no accesscontrol list <1‐256> ipv4 sourceipaddress
Deletes the configured source IP address for the specified ACL.
Command mode: Global configuration
accesscontrol list <1‐256> ipv4 typeofservice <0‐255>
Defines a Type of Service (ToS) value for the ACL. For more information on
ToS, refer to RFC 1340 and 1349.
Command mode: Global configuration