Protocol Independent Multicast Configuration
© Copyright Lenovo 2017
The following table describes the PIM commands.
Table 338.
PIM Configuration Options
Command Syntax and Usage
ip pim component <1‐2>
Enter PIM component mode.
Command mode: Global configuration
no ip pim component <2>
Deletes the PIM component.
Command mode: Global configuration
[no] ip pim enable
Globally enables or disables PIM.
Command mode: Global configuration
[no] ip pim pmbr enable
Enables or disables PIM border router.
The default setting is disabled.
Command mode: Global configuration
ip pim regstopratelimitperiod <0‐2147483647>
Configures the register stop rate limit, in seconds.
The default value is 5 seconds.
Command mode: Global configuration
default ip pim regstopratelimitperiod
Reset the register stop rate limit to its default value of 5 seconds.
Command mode: Global configuration
no ip pim regstopratelimitperiod
Disables the register stop rate limit.
Command mode: Global configuration
[no] ip pim staticrp enable
Enables or disables static RP configuration.
The default setting is disabled.
Command mode: Global configuration
Chapter 4: Configuration Commands
613