Toshiba Perfecptione Installation And Maintenance Manual page 135

PROGRAMMINGPROCEDURES
SECTION 200-255-305
FEBRUARY1992
TABLE 5-4
Procedure - System Data Block 2
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM
PROMPT USER ENTRY NOTE
OK
DSD2
- DISK LOADING -
REQ
1 CH&
I
Master DNO #0
MD0
1 - 4 Digits (NONE) 1
Master DNl #I MD1 1 - 4 Digits (NONE) 1
Master DN2 #2
MD2
1 - 4 Digits (NONE) 1
Master DN3 #3
MD3
1 - 4 Digits (NONE) 1
Lodging/Health Care AHM
Y or N (N)
2
Night Operator Station NOS
XXXX or NONE (NONE)
3
Transfer Recall Timeout
RTO
1 - 255 seconds (30) 4
Attendant-Position Electronic/Digital
Telephone
AEKT
LNNX, LNNX... (NONE) 5&6
D
LNNX, LNNX.. . 5&7
A
LNNX, LNNX. . . 5, 8, & 9
PERCEPTlONe, PEX Y or N (Y)
10
Call Distribution algorithm CDA
NAF, MIF (NAF) 11
Stroke Count Length
SCL
1,2,3,4, or None (NONE)
12
MIS Machine MIS
Y or N (N) 13
ACD Handsfree Answerback
AHA Y orN (N)~ 14
Handset Volume Preset Level
H-VP
1,2,3, or4 (2)
15
Default values are noted in parentheses ( ).
NOTES:
(continued)
1. This entry cannot be changed back to NONE.
2. Y = Lodging/Health Care mode (HRM must also be entered in DCOS Data Block). N = Business
mode.
3. XXXX = The directory number to which dial 0 calls will go when the system is in night service.
NONE = UNA.
4. If a system utilizes a voice mail system, it is recommended that this timer be set rather short so that
voice mail can be activated promptly.
5. LNNX denotes the station port number of the electronic/digital telephone that is to be assigned (or
is to be added or deleted) as an attendant-position electronic/digital telephone.
6. Data which appears represents old entries. If no old data exists, then the system will respond with
"NONE. '
7. "D" represents a deletion. Any port number that is entered in response to this prompt will be deleted
as an attendant-position electronic/digital telephone.
8. "A' represents an addition. Any port number that is added in response to this prompt will be added
as an attendant-position electronic/digital telephone.
9. Up to eight port numbers (eight electronic/digital telephones) may be added or deleted in any one
line. There is a maximum of eight attendant-position electronic/digital telephones per system,
10. Designates whether or not the system is a PERCEPTIONex.
Y = PERCEPTIONex. N = PERCEPTlONe.
5-11