Toshiba Perfecptione Installation And Maintenance Manual page 158

PROGRAMMING PROCEDURES
SECTION 200-255-307
FEBRUARY 1992
7. There is a maximum of 500 Autodial a buttons per system.
8. XXX = Fixed digits to be dialed (maximum: 16 digits/* = pause).
9. This feature can on/y be assigned to 2000~series electronic/l OOO-series digital LCD telephones.
IO. The Flash button causes a 500 ms or a 1 -second flash to a CO trunk.
11. XX = Leading one or two digits (1 - 9) designating the Hundreds Group to be activated on an associated
DSS console (switched operation only).
12. LNNX = The port number of the electronic/digital telephone to be signaled.
13. External Paging is used to access External Paging Zones (0 - 4).
14. Internal Paging is used to access Internal Paging Groups (0, 2 - 17).
15. SDC XX makes the station a controller of Station Speed Dial list XX (XX = 01 - 50).
SDU XX makes the station a user of Station Speed Dial list XX (XX = 01 - 50).
16. A System Night Button m can be assigned to one attendant-position electronic/digital telephone per
tenant if an attendant console is not assigned to that tenant.
17. XXXX = The DN of the station that is to receive a Voice Page.
= Ignore line entered.
= Backspace.
= Stop printing
and return to REQ.
= Exit program.
TABLE 7-2 (continued)
Error Codes
I
Program Name: Electronic Telephone Data Block (DEKT)
I
Error Code Meaning
EREKT 00 A PCB is not equipped at that location.
~.
EREKT 01 1 The PCB is an NSTU type (not an NEKU/NDKU).
I I
1 EREKT 02 1 The port is busy (REQ = CHG or OUT).
EREKT 03 The port has already been assigned to a station, DSS console, or DDIU (REQ = NEW).
I
EREKT 04 1 1 was entered, but tenant service was not enabled in the Svstem Data Block.
EREKT 05 1 was entered, but Attendant 1 was not programmed (no Attendant Data Block).
EREKT 06 Wrong button number (over permitted button strip number).
EREKT 07 Assigned port LNNX is not assigned as a station port (Manual Signaling). -.
EREKT 08 1 The maximum number of m buttons has already been assigned (maximum: 500).
EREKT 09 PUG was entered, but a Call Pickup Group number is not assigned.
EREKT 10 The DN conflicts with existing DN.
EREKT 11 510 DNs have already been assigned in the system.
IEREKT12 1
The DN has already been assigned to its maximum number of appearances (Primary is 1,
Secondary is 95).
EREKT 13 "Call Pickup Group number = NONE" was entered, but m button has already been assigned.
EREKT 14 The next hunt DN is not assigned.
EREKT 15 A DN has already been assigned to the port.
1 EREKT 16 1 The input DN has already been assigned to this station.
I
EREKT 17 The input data was erased because the program was aborted during a NEW data entry.
EREKT 18 The port is not assigned.
EREKT 19 The port is assianed to an NSTU PCB.
7-11