Toshiba Perfecptione Installation And Maintenance Manual page 196

PROGRAMMINGPROCEDURES
SECTION 200-255-309
FEBRUARY1992
5. Station Message Detail Recording Data Block
(Table 9-5)
5.01 The Station Message Detail Recording Data
Block (DMDR Program) defines the account code
length and type of calls to be recorded for each
trunk group for the SMDR feature. Data is entered
as follows:
REQ (Request)-Indicates that the program has
loaded. Three responses are possible:
NEW-To create a new Data Block.
CHG-To alter an existing Data Block.
OUT-To delete an existing Data Block.
TPN (Trunk Port Number)-Allows Trunk Port
Numbers to be printed in the SMDR report.
Enter: Y to allow; N to deny.
ACL (Account Code Length)--Defines the length
of the account code that is to be used or indicates
that no account code is to be used.
Enter: Number of digits to be used (1 - 12) or
NONE.
NOTE:
The account code length must be programmed
in order for the account code features (Volun-
tary, Verified and Forced) to be enabled.
SPCCI (Specialized Common Carrier #l )-In-
forms the system of the DN that is used to access
an SPCC (MCI, Sprint, etc.). The system will
recognize the DN and enter a unique condition
code in the SMDR output.
Enter: SPCC Number NXXXXXX or
Equal Access Number 1 OXXX or NONE.
SPCC2 (Specialized Common Carrier &+-Same
as SPCCI , but for a second carrier.
Enter: SPCC Number NXXXXXX or
Equal Access Number 1 OXXXor NONE.
NOTE:
Data that is entered here will also appear at
the SPCCI and SPCC2 entries in the DTOL
Data Block. SPCCI and SPCC2 entries..will
not appear in the SMDR output.
TGP (Trunk Group)-Defines the type of calls to
be recorded by SMDR for a given trunk group.
Enter: XX YYY.
(XX = Trunk group number.)
(YYY = INC-Incoming only
OGT-Outgoing only
IAO-Incoming and outgoing
TOL-Toll calls only
INT-Incoming-all; Outgoing-toll only
NONE-No records.)
Repeat for each trunk group that is used
in the system.
NOTE:
A call made by using an SPCC is not treated
as a toll call for SMDR purposes.
9-16