Toshiba Perfecptione Installation And Maintenance Manual page 155

PROGRAMMING PROCEDURES
SECTION 200-255-307
JANUARY 1993
TABLE 7-2
Procedure - Electronic/Digital Telephone Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM ': PROMPT
USER ENTRY NOTE
OK DEKT
- DISK LOADING -
I
I
REQ
I NEW, CHG, OUT
I1
Port Number POR LNNX
l&2
Digital Key Telephone
DKT Y or N
Number of Buttonstrips
KS
1 or2
3
Class of Service Group cos o-15
4
Tenant Number
I
TEN
I
0 or 1
I
5 I
Call Pickup Group
I
PUG
I
0 - 31 or NONE
1 -61
Warning Tone Allowed?
Call Forward to Trunk
Toll Restricted Class
WTA Y or N
CFT Y or N
TOL 0-8orNONE
7 I
Not Used
I
mA
1 N I
Handsfree Answerback Equipped? I
HFA
I Y or N
I
Display Electronic/Diqital Telephone I
DIS 1 1,2, or NONE
1-s
Paging Group
Emergency Ringdown Station
Ring State Preselection
PA0
RDS
RSP
0,2-17,0rNONE
1 - 4 digits, ATT, UNA, or NONE (NONE)
Y or N
9
IO
Off-hook Call Announce Port
Off-hook Call Announce
OCP
OCA
LNNX or NONE
A or M
l&2
Button Assignments (lo-button) I KEY
I
o - 9 [space] Feature
l11-13
Button Assignments (20-button)
I KEY
I
0 - 19 [space1 Feature Ill - 13
L
Default values are noted in parentheses ().
(continued)
NOTES:
1. NN = PCB location.
2. X = circuit number.
3. 1 = 1 O-button electronic/dig~tal telephone. 2 = ZO-button electronic/digiital telephone.
4. There are 16 different COS groups, which are defined in the Class of Service Data Block.
5. When RNA calls recall to the Attendant, they will recall to the Attendant (0 or 1) that ORIGINALLY transferred the call.
6. There is a maximum of 32 Call Pickup Groups.
7. Classes 0 - 7 are defined in the Toll Restriction Data Block (DTOL Program). Class 8 = 1 ori restriction.
.~ NONE = No Toll Restriction.
8. I= ZOOO-series LCD electronic telephone. 2 = 6000-series electronic or 1 OOO/ZOOO-series digital LCD. NONE = Not an
LCD electronic/digiital telephone.
9. The four possible paging groups to which an electronic/dgiital telephone can belong are 0, or 2 - 17. NONE indicates
that an electronic/digital telephone does not belong to any paging group. There is a maximum of 32 electronic/digiial
telephone members for groups 2 - 17 and a maximum of 96 for group 0.
70. The emergency ringdown destination will be signalled when the DPTand LLO timers (from the DSYSprogram) expire.
11. Enter button number followed by a space and then the entry. Button 0 must be the station's primary DN. See Table
7-2a for possible entries.
12. Button numbers may be entered in any order. The KEY prompt will be repeated untilm is entered.
13. If KS was 1, 0 - 9 will be allowed. If KS was 2, 0 - 19 will be allowed.
= Ignore line entered.
Stop printing and return to REQ.
7-8
.I