Toshiba Perfecptione Installation And Maintenance Manual page 255

PROGRAMMINGPROCEDURES
SECTION 200-255-318
FEBRUARY1992
TABLE18-1
Procedure-Verifiable Account Codes Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM PROMPT
OK
DVAC
- DISK LOADING -
USER ENTRY NOTE
REQ
CHG
Account Code Add
I
TYPE
I
ACTA
I
Account Code Length
ACL
No entry required
1
Account Codes to Add
A
1 - 12-digit Account Codes 2
Account Code Delete
TYPE
ACTD
Table Number
TABLE NO.
o- 14 3
Account Code Number
ACTX
No entry required
D
1 - 4 digits
4
5
(continued)
NOTES:
1. No entry is allowed here. This will be the same information from the ACL prompt in the DMDR
Program.
2. You may add more than one account code. If you add m&e than one account code, put a space
between each. The length of the account code must match the length specified in the ACL prompt.
3. There is a maximum of 75 tab/e numbers. (Use P VAC: T5L ACL to identify which table a code is
in.)
4. The system will print out the account codes that have a/ready been programmed in the fable
entered in the TABLE NO. prompt.
5. Enter the corresponding number(s) of the account code(s) you wish to delete.
= Ignore line entered.
= Backspace.
= Stop printing and return to REQ.
= Exit program.
TABLE18-la
NUMBER OF
VERIFIABLE ACCOUNT CODES
ACL DIGIT LENGTH 12,ll 10,9 8,7 6,5 4 3 2 1
NUMBER OF CODES 500 600 750 1000 1500 1000 100 10
NUMBER OF CODES PER TABLE 50 50 50 50 100 100 100 10
TABLE NUMBERS USED o-9 o-11
o-14 o-19 o-14 o-9 0 0
18-2