Toshiba Perfecptione Installation And Maintenance Manual page 271

PROGRAMMING PROCEDURES
SECTION 200-255-319
FEBRUARY 1992
TABLE 19-5a (continued)
7 7. Dialing was not complete when
q
was entered. A second
q
is required.
12. Enter the port number (TNNX) of the trunk (B) to be tested.
73. Requested trunk was idle and has been
seized.
14. Requested trunk (B) is busy.
15. Requested trunk (B) does not exist in the system.
16. Enter the DN that should be dialed by the trunk under test, followed by a
q
,
17. After the dialing is complete, the audio from the trunk under test will be heard via the monitor link. Enterm
when the test
is complete.
18. The test has ended. The program will automatically return to the TRKprompt to allow another trunk to be
selected.
19. The trunk under test(B) was released due to a ma/function or outside influence, such as the distant endgoing
on-hook (ground start).
20. [9
was
entered
while
Trunk
B
was
still
dialing. (See
Note 17.)
TABLE 19-5 (continued)
Error Codes
Error Code
ERTPE 00
Program Name: Peripheral Diagnostic Data Block (TPER)
Meaning
The PCB tvoe conflicts with customer data.
ERTPE 01 A PCB is not equipped in that location (enable).
ERTPE 02 The cable is open or the port is inhibited by heavy traffic (enable).
ERTPE 03 The entered port is a maintenance terminal (enable).
ERTPE 04 No PCB is eauiooed in that location (disable).
ERTPE 05
ERTPE 06
The port is busy.
The PCB number or electronic/digital telephone number is out of range.
ERTPE 07
ERTPE 08
The PCB type is not an NSTU or NEKWNDKU.
The PCB type is not a trunk.
~~~ ~ -1 ~~ ~ -
ERTPE 09
The PCB tvoe is not a DTMF receiver.
I
ERTPE 10
ERTPE 11
The entered PCB type is incorrect.
No PCB is eauiooed in that location (inhibit).
ERTPE 13
I
No PCB is
eQIJiDPed
in that location (REQ = CALL TNNX).
ERTPE 14
1 ~ ~~ ~~~~
The entered universal
sort
(slot) is uneauiooed or unassianed.
I
19-14