Table of Contents
Advertisement
PROGRAMMING PROCEDURES
SECTION 200-255-309
FEBRUARY 1992
CTL (Control
of Disconnect)-Defines
the re-
lease control of TIE, DID, or CCSA connection.
Enter: OPC (Originating
Party Control)-The
circuit will not be released
until the trunk
that originated
the call disconnects.
FPR (First Party Release)-The
trunk
at either
end of the connection
can
release.
DIN (incoming
Dialing)-Informs
the system
of
what type of dialing to expect
on an incoming
call. (This prompt
is for TIE, CCSA,
and DID
trunks only.)
Enter: DIP-Dial
Pulse.
TON-DTMF.
DOT (Outgoing
Dialing)-Informs
the system
of
what type of dialing to expect on an outgoing
call.
Enter: PlO = Rotary Dial IO PPS.
P20 = Rotary Dial 20 PPS.
TON = DTMF.
OTR (Private Line Outgoing Call Restriction)--
This prompt
will only appear
if the trunk is a
member
of the private line trunk group (Group
15). The OTR prompt is used to exclude selected
stations
from making
outgoing
calls over the
private
line. Consequently,
these
lines can be
used only for answering
incoming
calls. If a
private
line appears
on more than one station,
then each station can be individually
restricted
from using the line for outgoing
calls by entering
the port number
of each DN that is to be re-
stricted (LNNX). Following
the OTR prompt, the
system will prompt
"D" and any entries made will
be deleted.
To add entries,
press the carriage
return m
key. An "A" prompt
will appear and
any entries made will be added.
Enter: LNNX
LNNX
(in response
to the
D
prompt)-To
delete a station port.
LNNX
LNNX
(in response
to the A
prompt)-To
add a station port.
TABLE 9-3
Procedure - Trunk Data Block
Authorization
Procedure
must be completed.
If OK response
is received,
proceed
as follows:
(continued)
Advertisement
Chapters
Table of Contents
