Table of Contents
Advertisement
calls received
via a port assigned
to a DNIS trunk
group.
REQ (Request)-Indicates
that the program
has
loaded.
Three responses
are possible:
NEW-To
create a new Data Block.
CHG-To
alter an existing Data Block.
OUT-To
delete an existing Data Block.
TAB (DNIS Table
Number)-Identifies
the DNIS
Table.
The system
can support
a maximum
of
125 DNIS tables.
Enter: 1 - 125.
NUM (Number
of Digits Received)-identifies
the
number
of digits sent by the CO.
Enter: 1 - 5.
PROGRAMMING PROCEDURES
SECTION 200-255-309
FEBRUARY 1992
DIG (Actual
Digits
Received)-Identifies
the ac-
tual DTMF/DP
digits received from CO.
Enter: XXXXX (1 - 5 digits).
DN (Destination
Directory
Number)-Routing
destination
for DNIS trunk. This can be an inter-
nal directory number, an ACD Group pilot number,
a Master Distributed
Hunting Group pilot number,
a voice mail port, the attendant
console (UNA in
Night Service),
or UNA in either Day or Night
Service.
Enter: XXXX (1 - 4 digits) or NONE (UNA).
NOTES:
1. When TEN = N in the DSYS Program,
programming
A TTO or A TTI with two con-
soles causes a load share condition.
TABLE 9-7
Procedure
-
Dialed
Number
Identification
Service
Data Block
Authorization
Procedure
must be completed.
If an OK response
is received,
proceed
as follows:
ITEM
PROMPT
USER ENTRY
NOTE
I
OK
1
DDNI
-
DISK LOADING -
I
REQ
I
NEW, CHG, OUT
I
I
DNIS Table Number
Number of Digits Received
Actual Digits Received
Destination
Directory Number
TAB
NOM
DIG
DN
l-125
1-5
xxxxx
1 - 4 digits
Alphanumeric
Display
I
DIS
I
~
16 characters
--~l--il
NOTES:
1. A maximum
of 125 DNIS tables is possible.
2. Number
of digits sent by CO.
3. Actual DTMF/DP
digits received
from CO.
4. Routing
destination
for DNIS trunk. This can be an internal directory
number,
an ACD Group pilot
number,
a Master Distributed
Hunting
Group pilot number,
a voice mailport,
the attendant
console
(UNA in Night Service),
or UNA in either Day or Night service.
5. Alphanumeric
characters
to be displayed.
If different
digits (DIG) were received
for different
calls,
and the calls were routed to the same Destination
Directory
Number
(DN), a different message
can
be displayed
for each call. (A - Z, 0 - 9 allowed
and SPACE/BLANK.).
--
= Ignore line entered
= Backspace.
= Stop printing
and return to REQ.
= Exit program.
9-19
Advertisement
Chapters
Table of Contents
