Toshiba Perfecptione Installation And Maintenance Manual page 269

PROGRAMMING PROCEDURES
SECTION 200-255-319
FEBRUARY 1992
TABLE 19-5a
TRUNK STATUS ENTRIES
ENTRY DESCRIPTION
RESPONSE
DSCDNNN
DSTKNNX
DSLCNNX
ENCDNNN
ENTKNNX
ENLCNNX
DSDSNNX
ENDSNNX
DSRCNNX
ENRCNNX
DSCIXXX
LIPS
LBPS
LDPS
STLCNNX
Sl-TKNNX
Disable PCB XXX immediately
Disable Trunk NNX'
Disable Line Circuit NNX'
Enable PCB XXX
Enable Trunk NNX'
Enable Line NNX'
Disable DSS Circuit NNX'
Enable DSS Circuit NNX"
Disable RCVR NNX'
Enable RCVR Circuit NNX'
Disable PCB XXX when idle
List all idle ports
List all busy ports
List all disabled ports
Status of Line Circuit NNX'
Status of TRK NNX'
PCB disabled, FAULT LEDs on
TRK disabled, FALT LED on, REQ prompted
Line disabled, FALT LED on, REQ prompted
PCB enabled, FALT LEDs off, REQ prompted
Trunk enabled, FALT LED off if all circuits are enabled, REQ prompted
Station line enabled, FALT LED off if all circuits are enabled, REQ prompted
DSS disabled, FALT LED ON, REQ prompted
DSS enabled, FALT LED off if all circuits are enabled, REQ prompted
RCVR disabled, FALT LED ON, REQ prompted
RCVR enabled, FALT LED off if all circuits are enabled, REQ prompted
Each port disabled when idle, FALT LEDs on
Idle ports = LNNX, TNNX, etc., REQ prompted
Busy ports = LNNX, TNX, etc., REQ prompted
Disabled ports = LNNX, TNNX, etc., REQ prompted
Type (Note 1) Status (Note 2)
5OQl2500
IDL, BSY
EKT
DIS CBL
UNEQ
DE -l-l-Y
UNAS
DIS TLD
Al-l-
REQ prompted
Type (Note 1) Status (Note 2)
WAT
IDL
Fx BSY
TIE
DIS l-l-Y
co DIS TLD
CCSA REQ prompted
UNEQ
UNAS
STDSNNX Status of DSS NNX'
Type (Note 1)
Status (Note 2)
IDL, BSY
DIS CBL
DIS l-l-Y
DIS TLD
STRCNNX
STCDXXX
Status of RCVR 00X'
Status of PCB XXX
Status = IDL, BSY, DIS TTY, DIS TLD, UNEQ, UNAS, REQ prompted
Circuit #1 = Same as STLC, STTK, STRC
Circuit #2 = Same as STLC. SlTK, STRC
Circuit #3 = Same as STLC, SlTK, STRC
Circuit #4 = Same as STLC, STTK, STRC, REQ prompted
l
NN = PCB number X = Circuit number
(confinuec
NOTE: When requesting status, etc., of a universal port (U slots), the entty must be as a line PCB (example: PCB in slot U26-entry: STCDLZG).
19-12