Table of Contents
Advertisement
PROGRAMMING PROCEDURES
SECTION 200-255-314
FEBRUARY 1992
CHAPTER 14
SPEED DIAL LIST DATA
1. Speed
Dial List Data Block (Table
14-I)
1.01 The Speed Dial List Data Block (DSDL
Pro-
gram)
contains
all numbers
stored
on the 90-
number
Speed
Dial - System
list and the 50 lo-
number
Speed
Dial - Station lists.
1.02 The DSDL Program
allows initial storage
or
changes
to any speed
dial list from the mainte-
nance terminal.
Data is entered
as follows:
REQ (Request)--Indicates
that the program
has
loaded.
Two responses
are possible:
CHG-To
alter an existing
or to enter a new
Data Block.
OUT-To
delete an existing Data Block.
LNO (List Number)-The
number
of the list to be
changed
or deleted.
Enter: 00 (for System List) or
01 - 50 (for Station
List).
STR
(Store
Number)-This
prompt
requests
the
number
to be stored.
Enter: Address code, space, and number in the
following
format:
Example:
0 9*NPANNXXXXX
1 9*NPANNXXXXX
NOTE:
In these examples,
9 is a trunk access code.
Therefore,
a """is entered to cause a 3-second
pause for dial tone delay. The "*"is counted as
one of the 16 allowable
digits.
NOTE:'
If the OUTcommand
was entered in response
to REQ above,
then no other data is required.
14-l
Advertisement
Chapters
Table of Contents
