Table of Contents
Advertisement
PROGRAMMINGPROCEDURES
SECTION 200-255-312
FEBRUARY1992
TABLE12-2
Miscellaneous
Parameters
Table
Load the DLCI
Utility
Program.
When TYPE is prompted,
proceed
as follows:
ITEM
1 PROMPT
1
USER
ENTRY
I
NOTE
I
TYPE
1
-PAR
I
Interchangeable
Codes
"0" Call Timeout
ICC
OTO
Y or N
Time in seconds: 0 - 99
1
Return Dial Tone after LCR Access Code
Warning Tone to caller when the
most expensive route is selected
RTD
WTA
Y or N
Y or N
Home Area Code
!
.lxAc
NO/l X (Home Area Code)
2
Toll Free (800) calls permitted via the
Local Call Route
I
TFC
I
Y or N
Local Call Route
I
I
I
LCR
1 XX (Local Call Route Table 1 - 15)
1
Long Distance International
(011)
Call Route
Directory Assistance (555) Call Route
DDD Prefix
LDO
LDI
DDP
1 - 15
l-15
1 - 3 digits or NONE
6
NOTES:
7. Informs
the system if interchangeable
codes are used (Office Codes with NO/IX format).
2, Defines
the area code in which the system is located. Home area codes are used to route dialed
numbers
which do not contain an area code. This entry is coupled
with the HAC entry in the PAR
table Toll Restriction
(DTOL Program).
Data that is entered
here will also appear
in that table.
3. These calls will be routed
via the Local Call Route.
4. Folio wing the S
esystem
willpromptan
"A. "Anyentriesmade
willbeadded.
Todelete
a code, press
key. The system will then prompt
"D," and any entries made will be
deleted.
Codes cannot be added and deleted in the same pass through
the table. A separate
pass
is required
for each step,
5. Route
Table to be used for 555 calls.
6. Route
Table to be used for 017 calls. A route tab/e number
is entered
here, however,
it is not
necessary
to create an RTB table for that route. This is for 011 calls only, 01 calls will follow the
local call route.
= Ignore line entered.
= Backspace.
-
Stop printing
and return to REQ.
1
Exit program.
12-3
Advertisement
Chapters
Table of Contents
