Toshiba Perfecptione Installation And Maintenance Manual page 270

PROGRAMMING PROCEDURES
SECTION 200-255-319
FEBRUARY 1992
TABLE 19-5a (continued)
ENTRY
DESCRIPTION RESPONSE
CALL TNNX
Sets up SYSTEM USER ENTRY NOTE
monitor link
using TNNX
WAIT
q
4
STS TLK.. .or.. .
Automatic advance to DN Prompt
STS WAIT...or...
q
5
STS OVR
mm
6
DN
mm
7
DDL
El
8
STS TLK...or...
Automatic advance to TRK prompt 9
STS RLSA...or... Automatic return to REQ prompt
10
STS DDL
q
11
TRK Call TNNX 12
(contimed)
NOTES:
1. Type: UNEQ = No PCB in that position.
LJNAS = PCB equipped but no data is assigned.
2. Status: IDL = Idle.
BSY = Busy.
DIS TTY = Manually disabled via TTY.
DIS CBL = Electronic/digital telephone port disabled by software due to open cable.
3. -
I
B
DIS TLD = Software disabled due to traffic load (indicates faulty PCB).
B
= Ignore line entered.
= Backspace.
D
= Stop printing and return to REQ.
B m = Exit program.
4. - is required to advance program.
5. Requested trunk (A) is busy. Enterm to try again.
6. Requested trunk (A) does not exist in the system. Enter-m m to return to the REQ prompt.
7. Enter the test center DN followed by a.
8. Allow time for completion of dialing and then enterm.
9. Dialing is complete; program advances to TRK prompt.
IO. Trunk A (monitor link) has been released due to a malfunction or an outside influence, such as the distant
end going on-hook (ground start).
19-13