Toshiba Perfecptione Installation And Maintenance Manual page 179

PROGRAMMING PROCEDURES
SECTION 200-255-308
JANUARY 1993
5. If M WC0 = VM, enter up to 32 directory numbers (NSTU ports) that will be connected to the voice
mail system.
If MWCI = VM, enter up to 32 directory numbers (NSTUporfs) that will be connected to the voice
mail system for Tenant 1 (TEN = Y).
NOTE: Do not make any entries for these two rompts if using the Toshiba INTOUCH or VP Digital
Voice Messaging System. Press the lb - key.
6. This entry will appear when MWCO or MWCl = VM.
7. If MWCO = VM and a Toshiba INTOUCH or VP Digital Voice Messaging System is being used,
enter up to 32 directory numbers (NSTlJpons) that will be connected to the iNTOUCH
or VP system.
If MWC1 = VM and a Toshiba INTOUCH or VP Digital Voice Messaging System is being used,
I
enter up to 32 directory numbers (NSTU ports) that will be connected to the INTOUCH
or VP system for Tenant #1 (TEN = Y).
Ignore line entered.
Backspace.
Stop printing and return to REQ.
Exit program.
TABLE 8-1, (continued)
Error Codes
Program Name: Message Center Data Block (DMCD)
Error Code
I
Meaning
ERMCD 00
All MDNs are assigned.
ERMCD 01
The DN you are trying to delete does not exist.
ERMCD 02
The MDN has already been assigned.
ERMCD 03
ERMCD 04
The DN does not exist in the system.
Data has already been assigned (REQ = NEW).
ERMCD 05
ERMCD 06
Data is not assigned (REQ = CHG).
MWCO or MWCl = VM, therefore AlTO or ATT1 cannot be entered. You
cannot enter Al70 at the MDN1 prompt, or ATT1 at the MDNO prompt.
,.. -..
I. "'Y
/-
:-
8-3