Toshiba Perfecptione Installation And Maintenance Manual page 245

PROGRAMMING PROCEDURES
SECTION 200-255-316
FEBRUARY 1992
CHAPTER 16
ALPHANUMERIC MESSAGING DATA
1. Alphanumeric Message Data Block (Table
16-1)
1.01 The Alphanumeric Message Data Block
(DMSG Program) changes system messages that
can be left on 6000-series electronic/l OOO-series
digital LCD telephones (five messages are
initialized).
Initialized Messages:
I
2
I
CALL
I
I
3
I
BACK AT
I
I
4
I
RETURN ON
I
REQ (Request)-Indicates that the program has
loaded. The only response possible is CHG.
MSG
(Message)-Assigns
the ten system alpha-
numeric messages.
Enter:
1) The number of the message to be defined.
Thesystem willautomaticallyenteraspace
after the number. Messages are numbered
0 - 9. Following the message number and
space, any existing message will be out-
put. Type the new message (the existing
message will be replaced). NONE deletes
any existing message but does not add a
new one.
2) The available message characters are: 0
- 9, A - Z, [space], :, -, ?, +, /. Messages
can be up to 16 characters in length.
TABLE 16-I
Procedure - Alphanumeric Message Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM PROMPT USER ENTRY NOTE
OK DMSG
- DISK LOADING -
REQ CHG I
I
Message
I *Q I Message Number (0 - 9) + [space] +
Message or NONE
I
l&2
NOTES:
1. The system will output a space after the MSG number is entered, followed by an existing message
(if no message exists, then this will remain blank) and another space. Enter the new message or
NONE (to delete the message).
2. The characters available for messages are 0 - 9, A - Z, [space], :, -, ?, +, /.
Stop printing and return to REQ.
Error Codes
Program Name: Alphanumeric Message Data Block (DMSG)
Error Code
I
Meaning
1 ERMSGOO 1
Message is too long (maximum: 16).
I
ERMSG 01 Message can only use: 0 - 9, A - Z, [space], :, -, ?, +, /.
I
16-l