Operations And Setting Procedure Example - Fujitsu 8FX Hardware Manual

CHAPTER 19 16-BIT PPG TIMER

19.6 Operations and Setting Procedure Example

19.6 Operations and Setting Procedure Example
The 16-bit PPG timer can operate in PWM mode or one-shot mode. In addition,
a retrigger function can be used in the 16-bit PPG timer.
■ PWM Mode (MDSE Bit in PCNTHn Register = 0)
In PWM mode, the 16-bit PPG cycle setting buffer register ch. n (PCSRHn, PCSRLn) values
are loaded and the 16-bit downcounter starts down-count operation when a software trigger is
input or a hardware trigger by TRGn pin input is input. When the count value reaches "1", the
16-bit PPG cycle setting buffer register ch. n (PCSRHn, PCSRLn) values are reloaded to repeat
the down-count operation.
The initial state of the PPG output is "L". When the 16-bit downcounter value matches the
value set in the duty setting registers, the output changes to "H" synchronizing with count
clock. The output changes back to "L" when the "H" was output until the value of duty setting.
(The output levels will be reversed if OSEL is set to "1".)
When the retrigger function is disabled (RTRG = 0), software triggers (STRG = 1) are ignored
during the operation of the downcounter.
When the downcounter is not running, the maximum time between a valid trigger input
occurring and the downcounter starting is as follows.
Software trigger
Hardware trigger by TRGn pin input : 1 count clock cycle + 3 machine clock cycles
The minimum time is as follows.
Software trigger
Hardware trigger by TRGn pin input : 3 machine clock cycles
When the downcounter is running, the maximum time between a valid retrigger input occurring
and the downcounter restarting is as follows.
Software trigger
Hardware trigger by TRGn pin input : 1 count clock cycle + 3 machine clock cycles
The minimum time is as follows.
Software trigger
Hardware trigger by TRGn pin input : 3 machine clock cycles
340
: 1 count clock cycle + 2 machine clock cycles
: 2 machine clock cycles
: 1 count clock cycle + 2 machine clock cycles
: 2 machine clock cycles
FUJITSU SEMICONDUCTOR LIMITED
MB95630H Series
MN702-00009-2v0-E