At One-Shot Position Detection - Fujitsu 8FX Hardware Manual

CHAPTER 21 MULTI-PULSE GENERATOR
21.5 Operations
21.5.4.6

At One-shot Position Detection

The output timing change, which is triggered by the input pin SNIx for the one-
shot position detection, is shown in Figure 21.5-22.
■ When One-shot Position Detection
The operation of one-shot position detection is the same as that of the position detection,
except that after the first valid position is detected, no further position detection is recognized
until the operation mode is changed from one-shot position detection to another operation
mode. The OPTx output waveform is shown in Figure 21.5-22.
The reload timer is free to be used in this operation mode.
■ Timing Generated by One-shot Position Detection (OPS[2:0] = 0b110)
Figure 21.5-22 Timing Generated by One-shot Position Detection (OPS[2:0] = 0b110)
SNI2
SNI1
SNI0
RDA[2:0]
0b100
(OPDUR)
WTIN1
WTO
OP0[1:0]
0b00
(OPDLR)
PPG
OPT0
OPS[2:0]
414
0b110
0b01
0b110
FUJITSU SEMICONDUCTOR LIMITED
MB95630H Series
0b010
MN702-00009-2v0-E
0b11