Gpz-Iple Dsp Resource Selection - NEC UNIVERGE SV9100 Features And Specifications

Unicast Mode Example
Auto Mode Example
By default routers do not pass Multicast packets between subnets. If you have IP phones in
❍
different subnets than the GPZ-IPLE, and you are trying to utilize Multicast paging, you have to
program the router to pass the Multicast packet. Routing of Multicast Packets is not a default
routing feature and should be confirmed with the manufacturer of the routing equipment.
The default multicast address utilized by the SV9100 is 224.0.0.10. It should be noted that many
❍
routing devices available do not support multicast within the range of 224.0.0.0/24 and may require
the default address to be changed in the SV9100.

GPZ-IPLE DSP Resource Selection

Three additional GPZ-IPLE DSP resource assignments are available. The new assignments are:
Common without Unicast Paging, Multicast Paging, and Unicast Paging. The new assignments
assist with keeping IP phones from using all available DSP resources when utilizing Unicast Paging.
When the DSP resource is set to Common without Unicast Paging the resource can be accessed by
anything but a Unicast page.
When the DSP resource is set to Multicast Paging the resource can only be accessed by a Multicast
page no other device/feature can access this resource.
When the DSP resource is set to Unicast Paging the resource can only be accessed by a Unicast page
no other device/feature can access this resource.
1265