Tandem Trunking On Hang Up Multiline - NEC UNIVERGE SV9100 Features And Specifications

2. Press Speaker or hang up.
 If Program 20-13-10 is set to 0, the Conference ends and the line keys go out.
 If Program 20-13-10 is set to 1, to manually disconnect the Conference, Forced Trunk Disconnect (i.e.,
Press the line key +
used by an extension other than the originating extension.
Method B – Tandem Trunking with Transfer Key
Multiline Terminal:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Hold to place the first trunk call on hold.
3. Place a second trunk call.
4. Press Transfer.

This sets up an Unsupervised Conference with both outside parties.
 The line keys for the trunks light solid red.
 To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press the line key +
code set of Forced Trunk Disconnect in Program 11-10-26) must be used by an extension other than
the originating extension.
Single Line Telephone:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press hookflash and dial
3. Place or answer second trunk call.
4. To set up the tandem call, press hookflash and dial
5. Hang up.
 This sets up a Conference between both outside parties.
Method C – Tandem Trunking on Hang up
Terminal:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Hold to place the first trunk call on hold.
3. Place a second trunk call.
4. Hang up.
 This sets up an Unsupervised Conference with both outside parties.
 The line keys for the trunks light solid red.
 To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press line key +
code set of Forced Trunk Disconnect in Program 11-10-26).
3 or the service code set of Forced Trunk Disconnect in Program 11-10-26) must be
*
1.
#
Multiline
1209
.
753
3 or the service
*
3 or the service
*