NEC UNIVERGE SV9100 Features And Specifications page 744

Program
Program Name/Description
Number
IP Telephone Terminal Basic Data Setup –
15-05-16
Authentication Password
Assign the authentication password for SIP
single line telephones.
IP Telephone Terminal Basic Data Setup –
15-05-45
NAT Plug and Play
This program is valid when Program 10-46-14
is On (NAT feature activated).
Select sending RTP port number to remote
Router, use from negotiation result (0) or
received RTP packet (1).
SV9100 uses this program to decide a
destination port of RTP transmitting packets
from GPZ-IPLE to a remote IP terminal. If
"0:OFF" is selected, the destination port of RTP
transmitting packets will be a SIP/SDP
negotiation result.(same behavior as before). If
you chose "1:ON", the destination port of RTP
transmitting packet will be the same port of a
source port of a receiving RTP packet on
GPZ-IPLE (GPZ-IPLE required).
IP Telephone Terminal Basic Data Setup –
15-05-47
Registration Expire Timer for NAT
On a per station basis, this setting defines the
SIP registration expiry timer.
If this value is set to 0, for a NAPT terminal, the
value in Program 84-23-01 is applied.
IP Telephone Terminal Basic Data Setup –
15-05-48
Subscribe Expire Timer for NAT
On a per station basis, this setting defines the
SIP Subscribe expiry timer.
If this value is set to 0, for a NAPT terminal, the
value in Program 84-23-02 is applied.
IP Telephone Terminal Basic Data Setup –
15-05-50
Peer to Peer Mode
On a per station basis enable or disable Peer to
Peer mode.
SIP Extension Basic Information Setup –
84-20-01
Registrar/Proxy Port
Define SIP station Proxy Port.
IPL Basic Setup – IP Address
84-26-01
Assign the IP address for each DSP on the
GPZ-IPLE.
IPL Basic Setup – RTP Port Number
84-26-02
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
Input Data
Maximum of 24 characters.
0 = Disable
1 = Enable
60 ~ 65535 seconds
0 = Disable
60 ~ 65535 seconds
0 = Disable
0 = Disable
1 = Enable
1 ~ 65535
xxx.xxx.xxx.xxx
0 ~ 65534
744
Default
No Setting
0
180
180
1
5070
172.16.0.20
10020