NEC UNIVERGE SV9100 Features And Specifications page 720

default Park access code
after the , ignoring everything after. In this case, either the Park access code must be
#
changed to not include a
the Polycom SIP Configuration Local Settings.
SIP Stations which support RFC 3842 (Message Waiting) receive Message Waiting Lamp
indications.
Video Codecs H.264, H.263, and H.261 are supported.
Video is supported when P2P for standard SIP is turned on. (Program 15-05-50 SIP Peer to
Peer Mode ON)
Auto start video when call is answered is not supported.
Standard SIP video Codecs are not supported across CCIS.
Standard SIP video Codecs are not supported across NetLink.
Standard SIP terminal can not negotiate video Codec with Softphone.
SIP protocol (RFC3261) is used.
SIP Station uses the GPZ-IPLE as a media gateway.
Default UDP listen port for a SIP station is 5070.
UNIVERGE SV9100 Station registration policy supports an authentication feature. Enabling
this policy prevents the registered telephone from unexpected override.
UNIVERGE SV9100 supports HOLD and TRF feature on the basis of
draft-ietf-sipping-service-examples-09.txt
Section 2.5 (Transfer - Attended) of draft-ietf-sipping-service-examples-15.txt
draft-ietf-sip-session-timer-10.txt
When all VoIP DSP resources are busy, the SIP phone cannot preempt active calls to
make a 911 call.
The UNIVERGE SV9100 GCD-CP10 is the registration server for the SIP stations. The
configurable IP Address is located in Program 10-12-09 (SV9100 Network Setup – IP
Address).
T.38 (Fax) is supported for 3rd Party SIP "IP Single Line Telephone (SIP)" station ports.
Program 15-03-03 must be set to 1 (Special) at the receiving terminal in order for T.38 to
function.
With SV9100 system software and GPZ-IPLE daughter board installed, half duplex
connections are not supported. For troubleshooting purposes, a managed switch capable
of port mirroring is required to capture packet data from the SV9100 IPLE Ethernet port.
When using 3rd party SIP stations, the SIP server name can not contain a parenthesis.
When out of band DTMF is used (via RFC2833), the GPZ-IPLE supports a payload of
96 ~ 127.
If a user on a standard SIP phone is talking to another station using Voice Announce (the
receiving station has not pressed speaker or lifted the handset) and the SIP phone user
presses transfer or hold, the call is terminated. A standard SIP call cannot be placed on
hold or transferred until the other party answers.
The Exclusive Hold Recall Timer is used when an internal call from a 3rd Party SIP
6 will not work from a Polycom device because it starts dialing
#
, or the Remove End-Of-Dial Marker option must be disabled in
#
720
draft.
IETF