NEC UNIVERGE SV9100 Features And Specifications page 716

Program
Program Name/Description
Number
15-07-01 Programmable Function Keys
Assign functions to multiline terminal line keys.
NEC recommends the following for the first
three programmable keys on a ML440:
Line Keys 1 and 2 = CAP Keys
Line Key 3 = Intercom Key
System Options for Multiline Telephones –
20-02-12
Forced Intercom Ring (ICM Call Type)
Enable/Disable Forced Intercom Ringing. If
enabled, incoming Intercom calls normally ring.
If disabled, Intercom calls voice-announce.
This should be set to Signal (1) or each ML440
should be set to Signal manually using dial access
code 723.
20-06-01 Class of Service for Extensions
Assign ML440 handsets to their own Class of
Service.
20-08-11 Class of Service Options (Outgoing Call
Service) – Protect for the Call Mode
Switching from Caller
Set this option for the ML440/G566/G266
handset Class of Service. When an extension is
set to ring mode for ICM calls, enabling this
option prevents callers from changing the call to
voice announce mode.
This setting should be Enabled (1) for the
ML440/G566/G266 handset Class of Service.
Call Forward Split Settings – Call
24-09-01
Forwarding Type:
Assign Call Forwarding Type and the
destination numbers for each extension/virtual
extension.
Call Forward Split Settings – CO Call
24-09-02
Forwarding Destination for Both Ring, All
Call, No Answer
Assign CO Call Forwarding Destination for ring,
all call, and no answer.
Input Data
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
* *
00 ~ 99 (Appearance
Function Code) (Service Code
852 by default)
*
( 08 + XXXX = CAP key where
XXXX is the CAP orbit number
0001-9999)
0 = Disable (Voice)
1 = Enable (Signal)
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
0 = Off
1 = On
0 = Call Forwarding Off
1 = Call Forwarding with both
ring
2 = Call Forwarding when no
answer
3 = Call Forwarding all calls
4 = Call Forwarding busy or no
answer
5 = Call Forwarding when busy
1 ~ 9, 0, #, *, R, @
Maximum of 24 digits
716
Default
.
0
Extension port
101 = Class 15
All other
extension port =
Class 1
COS 1 ~ 15 = 0
0
No Setting