NEC UNIVERGE SV9100 Features And Specifications page 780

Program Name/Description
Program
Number
22-02-01 Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
For the SIP System Interconnection, set each
trunk to 5 (E&M Tie Line).
44-02-01 Dial Analysis Table for ARS/F-Route Access
– Dial
Set the Dial digits for the Pre-Transaction Table
for selecting ARS/F-Route (eight digits
maximum: 1~9, 0
To enter a wild card/don't care digit, press Line
Key 1 to enter an @.
44-02-02 Dial Analysis Table for ARS/F-Route Access
– Service Type
Set the Service Type (0 ~ 3) for the Pre-
Transaction Table for selecting ARS/F-Route.
For the SIP System Interconnection, set each
Dial Digit to 2 (F-Route).
44-02-03 Dial Analysis Table for ARS/F-Route Access
– Additional Data
This is the F-Route Table set in Program 44-05.
ARS/F-Route Table – Trunk Group Number
44-05-01
Assign the Trunk Group to be used by the
F-Route Table.
This is the Trunk Group assigned to the SIP
System Interconnection trunks in Program 14-05-01.
ARS/F-Route Table – Maximum Digit
44-05-09
Input the maximum number of digits to send
when using the F-Route.
IPL Basic Setup – IP Address
84-26-01
Assign the IP address for each DSP on the
IPLE.
Operation
SIP Trunk E.164 Support
To make a call using E.164 number format:
#, @).
Input Data
Trunks 1 ~ 400
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
Maximum of eight digits.
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting)
0 ~ 100, 255
0 = No Setting
255 = Extension Call
0 ~ 24
xxx.xxx.xxx.xxx
780
Default
0
No Setting
0
0
0
0
172.16.0.20