To Activate A Relay - NEC UNIVERGE SV9100 Features And Specifications

General Purpose Relay Setup – Drive Timer
10-05-02
Setup
The drive timer controls how long the relay is in
a closed state before automatically changing
back to an open state.
GCD-CP10 Hardware Setup – General
10-21-05
Purpose Relay Switch on GCD-CP10
Used to enable/disable the General Purpose
Relay that is built into the GCD-CP10.
GCD-CP10 Hardware Setup – Drive Timer
10-21-06
Setup on GCD-CP10
The drive timer controls how long the relay is in
a closed state before automatically changing
back to an open state.
Service Code Setup (for Service Access) –
11-12-50
General Purpose Relay
This is the access code to enable/disable the
General Purpose relays.
After dialing the service code the user must
then dial the relay (0 ~ 8) to enable/disable the
relays.
0 = Relay on GCD-CP10
1 ~ 8 = Relay assigned on PGD
15-07-01 Programmable Function Keys
Assign a function key for General Purpose
Relay (Code 51 Add; Relay number 0 ~ 8).
Operation

To Activate a Relay:

Multiline Terminal
1. Press Speaker.
2. Dial 880.
3. Dial Relay Number (0~8).
 0 is for the relay on the GCD-CP10, 1~8 are relays on the PGD(2)-U10 ADP.
- OR -
1. Press the Line Key assigned as a General Purpose Relay (the key is lit).
Single Line Telephone
1. Lift the handset.
2. Dial 880.
0–64800
0 = No drive timer
1 = 0.1 seconds
2 = 0.2 seconds
3 = 0.3 seconds
.
.
64800 = 6480 (seconds)
0 = Off
1 = Relay 1 on GCD-CP10
2 = Relay 2 on GCD-CP10
0–64800
0 = No drive timer
1 = 0.1 seconds
2 = 0.2 seconds
3 = 0.3 seconds
.
.
64800 = 6480 (seconds)
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
* *
00 ~ 99 (Appearance
Function Code) (Service Code
852 by default)
518
0
0
0
880