NEC UNIVERGE SV9100 Features And Specifications page 70

Program
Program Name/Description
Number
Automatic Route Selection Service –
26-01-02
Network Outgoing Inter-Digit ARS Timer
With Networking, this timer replaces Program
20-03-04 when determining if all network
protocol digits are received. If ARS is enabled
at Site B, this timer can be programmed for 5 at
Site A. If ARS is disabled and Site B is using
F-Route for outbound dialing, this timer should
be programmed for 30 at Site A.
Automatic Route Selection Service – ARS
26-01-03
Misdialed Number Handling
If a user dials a number not programmed in
ARS, determine if the system should Route
over trunk group 1 (0) or Play error tone (1).
Automatic Route Selection Service – Class
26-01-06
of Service Match Access
With the ARS Class of Service Match Access
feature, you can determine whether or not the
system should allow a call based on the COS
assigned to the Dial Analysis Table (Program
26-02). This change can be used to create a
tenant-like application. It then uses the trunk
group set in the Additional Entry in Program
26-02-03 to place the out-going call. When this
feature is enabled, the calls are routed in
sequential order, and forward – provided the
Class of Service for the trunk groups match.
Automatic Route Selection Service –
26-01-07
F-Route Access COS Reference
Define the system options for Automatic Route
Selection (ARS).
Input Data
0 ~ 64800 seconds
0 = Route to Trunk Group 1
1 = Play Warning Tone to Dialer
0 = Disable (Off)
1 = Enable (On)
0 = F-Route
1 = ARS
70
Default
30
0
0
0