Mount Ipasolink Ex/A - NEC iPASOLINK EX Advanced Instruction Manual

MOUNT iPASOLINK EX/A

This section provides the installation procedures to mount iPASOLINK EX/A and its
Antenna onto a Pole. For the detailed descriptions for the Antenna Installation, see
the instruction manual attached to the Antenna.
Tools required for the installation are listed below.
4.1 For Placing Equipment

NOTICE
1. iPASOLINK EX/A (equipment) generates non-ionizing radiation. Installing the
2. The equipment should be installed in the appropriate site. Do not install it on
3. iPASOLINK EX/A should be installed as follows.
Following show the methods of direct-mounting antenna. Depending on configuring
system, the mounting methods differ.
iPASOLINK EX Advanced:I
4. MOUNT iPASOLINK EX/A
Wrench or Monkey Wrench
Screwdriver
Torque Wrench
equipment indoors may affect, which needs to take the adequate measures,
if occurs.
a slant or unstable spot. Improper installation raise the temperature inside the
equipment, which may damage the equipment.
 Accessing to the equipment is only by the SERVICE PERSONNEL or by
users who are WELL TRAINED WITH ENOUGH SKILLS AND
KNOWLEDGES regarding these restrictions, precautions and installation
sites.
 Accessing must be protected using a tool, locks, keys, and/or other means
of security, which should be managed by the authority who is responsible
for the installed site.
 The other end of the Grounding terminal should be connected to the
station earth point. For details, refer to
section.
NSTALLATION
Table 4-1 Tools
TOOLS
6. GROUND iPASOLINK EX/A
GGS-000546-01E
4-1