Table of Contents
Advertisement
8-16
Parameter
Duplex
MDI and MDIX
Flow Control
Sync ETH
LLDP Usage
LLDP Mode
ALS Usage
ALS Interval
5. When completed, click the
6.
Figure 8-15 Information Dialog Box
7. The
GGS-000547-01E
Table 8-4 ETH Port Setting Parameters (2 of 2)
Value
Description
Full
Fixed to Full duplex mode only.
MDI
Specifies the port media type. This option is disabled when the Speed
option selects AUTO.
MDIX
Enable
Enables the Flow Control function.
Disable
Disables the Flow Control function.
Enable
Sets to Enable or Disable the Synchronous Ethernet.
NOTE: When the RJ45 port supporting the 1Gbit/s enables Sync ETH,
Disable
specifying this port to the Equipment Clock Reference forcibly assigns
and fixes this port to Slave. In this circumstance, if the opposing site
has the same settings as well, the Ethernet link will not be able to get
established.
Enable
Selects to use LLDP.
Disable
Selects not to use LLDP.
Standard
Enables to run the standard DP MAC.
Proprietary
Enable to run NEC proprietary LLDP MAC. This option is helpful to
MAC
locate an iPASOLINK where L2SW discarding standard LLDP frames is
in between two iPASOLINKs' management ports.
Enable
Sets to enable/disable the Automatic Laser Shutdown function. This
option is available for optical ports only.
Disable
60 [s]
Sets the delay time to release the port from the ALS state when the
alarm is cleared. [unit: second, default: 60 seconds]
180 [s[
300 [s]
Information
dialog box appears. Click the
ETH Port Setting
parameters.
OK
button.
OK
window updates the information. Verify the displayed
iPASOLINK EX Advanced: S
Set ETH Function
button to proceed.
N
S
ET
ETWORK AND
YSTEM
P
ROVISIONING
Advertisement
Chapters
Table of Contents
